Cabinet Parameters – General

Width

The width of the cabinet from the outside of the left side to the outside of the right side.

Depth

The depth of the cabinet without front.

Deep page left right

Determines the bevel of the cabinet type front diagonally over the depth of the two sides right and left. It is also possible to enter a value and a number of degrees. To do this, the degree sign ° must be used.

Example: Deep side left right: 330 20°

Creates a cabinet with a side depth of 330mm on the left. The depth of the right side is calculated from the angle and the cabinet width.

Sloping roof L ̄ | R ̄ |

Determines the bevel left and right over two pairs of values. A pair of values consists of the chamfer at the top (measured horizontally) and laterally (measured vertically). It is also possible to enter a value and a number of degrees. To do this, the degree sign ° must be used.

Example: Sloping roof L ̄ | R ̄ |: 20° 100 0 0

Creates a bevel at the top left starting on the left side 100mm below the cabinet height with a 20° slope running upwards.