It is possible to create a corner cabinet via the Field Cabinet Type . A second cabinet is added to the main cabinet rotated by 90° (base cabinet). Both cabinets have the full list of parameters and can therefore be individually adapted.
90 ° corner cabinet assignment via ID
ID Cabinet Right A83
This field is automatically pre-populated when selecting the cabinet type as a corner cabinet. Here, for example, with the ID of the base cabinet A83
If you enter the sign ‘-‘, an existing cabinet can be removed.
With the character ‘+’, a cabinet is created and rotated by 90° and added to the existing one.
It is also possible to use an existing cabinet as a counterpart by entering its elements ID (or object name) in the field.
Define aperture for a 90° corner cabinet
For the main and base cabinet of a corner cabinet, an aperture can be defined on the left and right. The position and size are defined as follows:
- Width (X-inside): In relation to the position of the bezel of the adjacent cabinet
- Width (X-outside): In relation to the door front plus the front joint links or Right
- Thickness (Y-outside): From the front edge of the strongest door front of all segments
- Strength (Y-inside): … up to the strength of the aperture
- Height (Z-Bottom): From the lower edge of the lowest door front
- Height (Z-Top): Up to the upper edge of the top door front
Aperture Strength Addition OffY: 19 0 0 19
The parameter Aperture Strength Train OffY now influences these dimensions of the aperture:
- Thickness: Moves end-Y
- Train: Two values for addition to the calculated width (X-inside) and (X-outside)
- OffY: Shifts (offset) the aperture and thus (Y-outside)
The width (X-outside) can also be influenced horizontally indirectly via a front addition. Here, the end of the aperture changes and thus its width analogous to the beginning of the front.
Example: Aperture Strength Addition OffY: 30 50 19
Creates an aperture with
- Aperture thickness: 30mm
- Overlap of aperture and front: 50mm – thickness of the front joint vertical left or left. Right
- 19mm offset to front edge: 19mm
Define rear bezel for a 90° corner cabinet
Bezel Rear Strength Width Red°: 19 80 0
Depending on the setting of the red parameter, the rear panel can be built in two parts or one-piece and obliquely:
- Red 0: Two-piece and the bezel of the corner cabinet bumps into the bezel of the base cabinet
- Red 90: Two-piece and the bezel of the base cabinet bumps into the bezel of the corner cabinet
- Red between 0° and 90°: One-piece, diagonally over corner
If you set the strength to 0, a bar is built to the corner
- With width 0, the aperture can ultimately be switched off