How can the texture of a cabinet component be scaled?
The assignment of textures of objects in ElementsCAD such as cabinet, counter etc. is done via classes.Within a class, textures cannot be freely defined in Vectorworks, so that even a…
Tools in ElementsCAD
Cabinet parameters – Corner cabinet
It is possible to create a corner cabinet via the Field Cabinet Type . A second cabinet is added to the main cabinet rotated by 90° (base cabinet). Both cabinets…
Cabinet parameters – rear panel
Thickness of the rear wall and distance from the rear Here, the cabinet-wide the thickness of the rear wall and then with consecutive values for each segment from bottom to…
Cabinet parameters – Body
Corner formation of the body sides Here the corner formation can be set with successive values for the corners left bottom, right bottom, left top, right top. Possible values for…
Cabinet parameters – Front
Type of stop and bevel of the front per segment Determines the type of stop of a door within a segment and whether it is beveled or straight drawn in…
Cabinet parameters – lid
Lid protrusion The field consists of four values for the protrusion of the lid on the left, right, front, and back sides A value combination 30 15 15 0 would…
Cabinet parameters – base
Base height The height of the base up to the lower edge of the lower floor. The base height is included in the total height. Base position If the socket…
Cabinet Parameters – Segments
Height segment A cabinet consists of up to five superimposed segments. The height indicated here always refers to the middle of the intermediate floors. In the first segment at the…
Cabinet Parameters – General
Width The width of the cabinet from the outside of the left side to the outside of the right side. Depth The depth of the cabinet without front. Deep page…
Create an aperture
The menu command Aperture creates an aperture or double page around one or more cabinets strung together. Double page spread Produces double pages instead of an aperture.
Drilling Patterns – Free Drilling Patterns
Under Free drilling patterns it is possible to place individual drilling patterns by component ID. The drill patterns are numbered and are added or removed from the left list via…
Drilling Patterns – Mounting Plates
Under mounting plates, it is possible to assign the drilling patterns for the mounting plates to the door hinges defined under Front . A distinction can be made between inner…